WDNA-YJY/WDNB-YJY交联聚乙烯绝缘护套A(B)类无卤低烟耐火电力电缆可敷设在对无卤低烟且耐火有要求的室内、隧道及管道中。
WDNA-YJY23/WDNB-YJY23交联聚乙烯绝缘钢带铠装护套A(B)类无卤低烟耐火电力电缆适宜对无卤低烟且耐火有要求时埋地敷设，不适宜管道内敷设。
RVV：铜芯聚氯乙烯绝缘和护套软信号电缆RVVP：铜芯聚氯乙烯绝缘和护套编织屏蔽软信号电缆RVVP2：铜芯聚氯乙烯绝缘和护套铜带屏蔽软信号电缆RVVP3：铜芯聚氯乙烯绝缘和护套铝塑复合带屏蔽软信号电缆RVVP-22：铜芯聚氯乙烯绝缘和护套编织屏蔽钢带铠装软信号电缆RVVP2-22：铜芯聚氯乙烯绝缘和。
充油电缆主要电气性能：1.充油电缆直流电阻:20℃,0.4≤1480.5 ≤95.00.6≤65.80.8≤36.62.充油电缆绝缘电气强度：导体之间1min1kv不击穿导体与屏蔽1min 3kv不击穿3.充油电缆绝缘电阻：每根芯线与其余线芯接地，HYAT电缆大于3000MΩ.k。
1.5综合护套铁路信号电缆的理想屏蔽系数≤0.8；铝护套铁路信号电缆的理想屏蔽系数≤0.32型号、名称及规格型号名称敷设范围规格(芯)PTYV聚乙烯绝缘聚氯乙烯护套铁路信号电缆敷设在土壤、槽、管中，能承受一般的机械外力。
这样本公司的交联聚乙烯电力电缆的整体水平低于国内领先地位。
本公司生产的耐火型电力电缆为额定电压0.6/1KV铜芯电缆，还可以生产低烟无卤耐火电力电缆、高阻燃隔氧层耐火电力电缆，其耐火性能符合GB/T12666.6《电线电缆耐火特性试验方法》。
两线制变送器因为信号起点电流为4mA.DC，为变送器供给了静态作业电流，一起外表电气零点为4mA.DC，不与机械零点重合，这种“活零点”有利于辨认断电和断线等毛病。
并且两线制还便于运用安全栅,利于安全防爆。
两线制变送器如图一所示，其供电为24V.DC，输出信号为4-20mA.DC，负载电阻为250Ω，24V电源的负线电位最低，它即是信号公共线，关于智能变送器还可在4-20mA.DC信号上加载HART协议的FSK键控信号。
5、色序：白/蓝、白/红、白/绿，白/橙，白/棕，白/黄，白/紫，白/灰，白/黑等，也可用户指定.包装：盒装、胶袋装，轴装计算机电缆DJVPV,DJVVP,DJYVP,DJYJVP,DJYPV,DJYJPV,DJVPVP,DJYPVP,DJYJPVP,JVV,JVVPDJYPRV DJVPVR、DJ。
Our professional production and sales: SYV video line, SYWV TV antenna, shielding wire, RVV RVVP sheathed wire, AVVR sheathed wire, AVVR multi-fiber signal lines, RVSP twisted-pair shielded wire, RVS RVS 2 * 2 * 2 * 1.0 RVS 1.5 2.5 AVR 0.12 square red, black, yellow, green AVR 0.5 square red, black, red, yellow AVR 0.3 square black AVVR 4 * 0.3 square white sheath line (blue, green, white and yellow) AVVR 2 * 0.5 square sheathed wire (red, white Black) RVVP 2*0.75 square black sheath... Emergency for wire and cable. RVS RVS 2 * 2 * 2 * 1.0 RVS 1.0 2.5 coaxial cable, elevator cable, super five types of twisted-pair cable, microphone cable, flame retardant, all kinds of cables, teng teng whole series of monitoring all series security cable, wire and cable branch teng whole series of weak current system. Security engineering, control engineering, weak current system engineering, integrated wiring, bank monitoring engineering, network engineering, fire engineering area, remote, building security monitoring, entrance guard visible interphone special audio and video signals such as wire and cable. (SYV video cable, shielding cable, RVV RVVP sheathed cable, signal cable, rf SYV, AVVR) BV plastic, BVR plastic soft copper wire, copper wire RVSP485 twisted-pair shielded cable, RVS twisted-pair cable, RVB parallel lines, the RV cord, KVVP control shielded cable, KVVR control soft cable, KVV control cables and manufacuring HYA communication cable, VV power cable, RVVP shielded wire (1 ~ 30 core) RVV sheathed wire (2 ~ 30 core) AVVR sheathed wire line (2 ~ 30 core) SYV video line (75-3, 5, 7, 9)
二、执行标准 SPTL/QB2002.10－03三、使用特性 1.电缆导体的长期允许工作温度应不超过65℃，敷设环境温度应不低于0℃。
2.电缆敷设安装允许弯曲半径非铠装电缆应不小于电缆外径的10倍；铠装电缆应不小于电缆外径的15倍。
The armouring control cable is fabricated into a flexible assembly by different material conductors in metal sleeves with insulating materials.
100对及以上线对的电缆加有1％的预备线对，但最多不超过6对。
缆芯内的间隙用石油膏填充。
5、缆芯包带：用聚脂薄膜带绕包。
6、屏蔽：用轧纹（或不轧纹）金属带，金属带纵包于缆芯包带之外。
7、护套：黑色低密度聚乙烯。
产品名称与型号：表序号型号名称低烟低卤阻燃计算机电缆1DZR-DJYPV铜芯聚乙烯绝缘铜丝编织分屏蔽聚氯乙烯护套低烟低卤阻燃计算机电缆2DZR-DJYPV22铜芯聚乙烯绝缘铜丝编织分屏蔽钢带铠装聚氯乙烯护套低烟低卤阻燃计算机电缆3DZR-DJYPV32铜芯聚乙烯绝缘铜丝编织分屏蔽细。
GB1208-2016《电流互感器》第5.2项中规定标准的电流互感器二次电流为1A和5A，优选值为5A，当传输距离较大时应选1A。
线路功耗降低线路功耗与通过电流平方成正比，二次电流为1A的电流互感器比5A减低功耗25倍，即1A的功耗仅为5A的4%。
表1电流互感器测量回路的功耗传输距离加大下相同负载下，二次电流为1A互感器的传输距离是5A的25倍，这样可避免5/1A中间互感器或选用大容量互感器。
表2不同额定容量时的传输距离电线截面积小大中型工厂，当仪表和电流互感器安装距离较远(45.5m)时，从表2可以看出，当选用510VA电流互感器时，线截面积经计算需4mm3；若选用12.5VA电流互感器，线截面仅需1mm2。
电缆直埋安装时，1-35KV电缆直埋深度不小于0.7m。
10KV及以下电缆平行安装时，相互净距不小于0.1m，10-35KV不小于0.25m；交叉安装时距离不小于0.5m。
电缆敷设温度不低于0℃，弯曲半径：多芯电缆≥15(D+d)，单芯电缆≥20(D+d)，（D为电缆外径，d为导体外径）。
Spin cassette XF5-273 communication cable transfer box, adopting advanced technology at home and abroad, in accordance with the international advanced standard production in the eighty s of cable wiring equipment, for the city, the town of telecommunication network backbone cable and wiring cable transfer. Features: 1. The connection jumper adopts rotary clamp-type connection and is sealed with silica gel on the metal clip, because it is not only reliable and durable, but also easy to operate and repair without stripping. 2. The wiring terminals in the handover box shall be arranged in 25 pairs as a basic unit, consistent with the basic units of the local telephone cables and marked with Numbers on the terminals to facilitate construction and maintenance. 3. The structure, arrangement and installation dimensions of the wiring modules are exactly the same as those of 3M products and can be used for each other. 4. The box body is treated by electrostatic spraying, beautiful and generous, with clear lines, good anti-corrosion and waterproof performance and long service life. Main technical parameters: the environment temperature: - 40 ℃ ~ + 65 ℃ atmospheric pressure: 70 ~ 106 kpa relative humidity: 95% or less is random ends and insulation resistance between terminals and ground > 5 x 104 Μ Ω. When connecting any two ends and any terminals and grounding to 1000V ac, there shall be no breakdown or flying arc in 1min. Contact resistance between wire and terminal < 5 x lO - 3 Ω.
HJVV, HJVVP, HPVV communication cable: mainly used for transmitting audio, 150kHZ and below analog 2048kbit/s and below. Under certain conditions, it can also be used to transmit Numbers over 2048kbit/s. Used for short distance transmission. New sales department of our factory, micro: 15075619608? ? is not convenient to contact! ? HJVV, HJVVP, HPVV communication cable is introduced: used for distribution frame or switch to switch the internal connection between the device (including rural telephone bureau), such as the beginning of the line and terminal, for connecting the city telephone cable to the junction box or distribution frame, inner conductor wire diameter (mm) : 0.40, 0.50, 0.60, 0.70, 0.80, 0.90? Logarithm (yeah) : 5-1000? HPVV low frequency communication distribution cable distribution cable Broadband/product use: suitable for transmission between remote optical network units and users, and between buildings in building wiring. The high transmission is 30MHz and 100MHz respectively.
4.安装敷设温度：不低于0℃5.电缆允许最小弯曲半径：非铠装、联锁或编织铠装电缆不小于电缆外径的6倍铜带屏蔽或钢丝、钢带缠绕铠装电缆不小于电缆外径的12倍四、主要技术指标性能项目单位指标导体线芯直流电阻(20℃)Ω/km标称截面mm20.50.7511.251.52.5。