苏尼特右旗低烟无卤WDZ-通信广播电缆HYPV23
低烟无卤电缆，是指不含卤素（F、Cl、Br、I、At）、不含铅镉铬汞等环境物质的胶料制成，燃烧时不会发出有毒烟雾的环保型电缆。
低烟无卤电缆基本概述:● 其中卤素指针为：所有卤素的值≦50PPM(根据法规PREN 14582)● 燃烧后产生卤化氢气体的含量<100PPM(根据法规EN5067-2-1)● 燃烧后产生的卤化氢气体溶于水后的PH值≧4.3(弱酸性) (根据法规EN-50267-2-2)● 产品在密闭容器中燃烧后透过一束光线其透光率≧60%(根据法规EN-50268-2)● Pb<90PPM，Cd、Cr6+、Hg、PBBs、PBDEs均小于5PPM
低烟低卤、低烟无卤阻燃电缆特点及用途：本产品适用于交流额定电压450/750V及以下的地铁、高层建筑、商场、剧院、发电站、化学工厂、城市广场及其他公用事业等对电缆阻燃特性要求高的场合。电缆的无卤低烟、低卤低烟特性，当火灾发生时，蔓延速度慢，烟浓度低，可见度高，有害气体释放量小，便于人员撤离。
Low smoke zero halogen flame retardant cable insulation using crosslinked poly (do not contain halogen, sheath used do not contain halogen polyethylene thin hydrocarbon material, so the set of all materials do not contain halogen, chung cable cable released when small amounts of smoke, it won't produce a strong acid mist, functioning, toxicity is small.
执行标准：JB8734.5-1998产品数量长期大量供应包装说明200米/卷；500米/卷线芯材质无氧铜芯数1～24芯护套材质PVC/PE电线最大外径26（mm）标称截面0.12～2.5（mm2）RVVPRVVP屏蔽电缆缆芯：绝缘芯线绞合成缆，绕包聚酯薄膜带（PP带）RVVP屏蔽电缆护套：黑色/白色。
燃烧气体的腐蚀性小，也避免了对仪器设备的损害，低卤、无卤的特性，使得电缆材料在耐老化和耐紫外线及其它辐照性能大大提高，从而延长电缆的使用寿命。低烟无卤WDZ-通信广播电缆HYPV23
低烟无卤电缆使用特性：1.电缆额定电压UO/U:450/750V，交流聚烯烃UO/U为0.6/1KV2.电缆长期工作温度为：-20℃－90℃，-40℃－105℃3.推荐弯曲半径：无铠装电缆应不小于电缆外径的6倍，有铠装或铜带屏蔽结构的电缆应不小于电缆外径的12倍。
低烟无卤电缆主要技术指标：1.电缆应经受环境温度下工频电压试验3kV，5min不击穿2.电缆的透光率应符合下表电缆外径 D（mm）透光率（%）≥电缆外径 D（mm）透光率（%）≥D>40705
380V工作电压的负载每千瓦是2A左右）。各配电回路选择好了合适安全载流量的导线之后、就按照各回路导线安全载流量匹配多少A脱扣电流值的断路器或漏电断路器来保护才能保障线路安全。下面我给出家庭单相220V配电常用铜芯导线安全负载功率供大家参考；前面的数字是铜芯导线的截面积“平方毫米”、后面的数字是其安全负载功率“千瓦”。1平方毫米=1.3千瓦左右。5平方毫米=2千瓦左右。5平方毫米=3.5千瓦左右。
This process specification provides for rated voltage 450/750v, single core 1.5-500mm2 PVC insulated or polyolefin insulated flame-retardant fire resistant soft cable; And 0.6/1kv single core 4~500mm2, 2~5 cores 1.5~240mm2 polychlorinated insulated or polyolefin insulated flame-retardant fire resistant flexible cables process specifications, technical requirements, and acceptance rules. The main models of this process specification are: rated voltage 450/750v: za-rv; WDZA - RY, etc. Rated voltage 0.6/1kv: za-rvv, za-rvv22, wdza-ryy, wdza-ryy23, wdna-ryy, wdna-ryy23. 2? Usage characteristics, classification and nomenclature of cables 2.1? Service characteristics 2.1.1 cable rated operating voltage: 450/750v, 600/1000v. 2.1.3 temperature under installation should not below 0 ℃. 2.1.4 small bending radius of cables: unarmored cables: the flame retardant type is 6 times the outer diameter of cables, and the fire resistant type is 12 times the outer diameter of cables; The armored cable is 20 times the outer diameter of the cable. 2.2? The cable type consists of 5 parts: serial code, insulation, sheath material code, outer sheath and performance code.
Precautions for installation of power cables: keep 2m distance when the cable is installed in parallel with the thermal pipe, and 0.5m should be maintained when crossing. The cable shall be installed at a distance of 0.5m in parallel or across other pipelines. When the cable is directly buried and installed, the direct buried depth of 1-35kv cable is less than 0.7m. When 10KV and below cables are installed in parallel, the net distance between them shall not be less than 0.1m and 10-35kv shall not be less than 0.25m. The distance of cross installation is not less than 0.5m. Cable laying temperature lower than 0 ℃, bending radius: multi-core cable or 15 (D + D), a single cable 20 or more (D + D), (D for cable diameter, D) for the conductor diameter. ? 6KV and above cable connector:? When installing the terminal head of the cable, the semiconductor electrical shielding layer must be stripped off. During operation, the insulation shall not be damaged. The shield end should be flat and the graphite layer (carbon particles) should be clean. (2) plastic cable end copper tape screened and armor must be good grounding, the short circuit also follow this principle, avoid unbalanced three-phase run ShiGang armoured end produce inductive electromotive force, and even "lighter" and sheath and other accidents. It is required to use my tinplate to braid copper wire for grounding lead. When connecting with the cable copper belt, it should be welded with chromium-iron tin. ? The shield of three-phase copper tape should be connected with ground wire respectively. Note that the shielded ground wire and steel armor ground wire should be separately drawn out and insulated from each other. The position of the welded ground wire should be as low as possible. Basic requirements for cable terminals and intermediate joints: a. good conductor connection; B. The insulation is reliable, and it is recommended to use irradiated cross-linked heat-shrinkable silicone rubber insulation materials; C. good sealing; D. sufficient mechanical strength to meet various operating conditions. The end of the cable must be used to prevent water and other corrosive materials from corroding, in order to prevent the water tree caused by the aging of the insulation layer and breakdown. Crane or forklift should be used for the loading and unloading of cables. It is forbidden to run flat or lay flat. For installation of large cables, cable laying cart should be used to avoid external damage or abrasion caused by manual dragging. If the cable cannot be laid in time for some reason, it should be stored in a dry place to prevent sunlight from exploding and water entering the end of the cable. ? Note: the installation of wire and cable should be familiar with the performance of wire and cable installation personnel or full-time technical personnel, if there are still unclear matters, ball related technical department or technical department of our factory.
型号及名称2271EC52（RVV）铜芯聚氯乙烯绝缘聚氯乙烯护套（圆型连接软电线）2271EC52（RVV）主要技术参数标称截面芯×（mm2）线芯结构芯×根/直径电线参考数据外径（mm）重量（kg/km）20℃时导体电阻（Ω/km）不大于下限上限2×0.52×16/0.2。
低烟无卤电缆代号、名称及含义：项目代号含义系列代号DLDWLDK低烟低卤低烟无卤控制电缆绝缘材料VJEF聚氯乙烯交联聚烯烃丁腈热塑体护套材料VGS聚氯乙烯热固性护套热塑性护套屏蔽材料PP2铜网或镀锡铜网铜带/塑复合带铠装材料2232钢带细钢丝导体种类ABR独股导体7股绞合导体多股绞合导体；生产范围截面(mm2)：0.5、1.0、1.5、2.5、4、6、10、16、25。
低烟无卤电缆主要用途：该产品阻燃性能优越，燃烧时烟度甚少，无腐蚀性气体逸出，广泛应用于核电站、地铁车站、交换机及计算机控制中心、高层建筑大楼、宾馆、广播电视台、重要军事设施、石油平台等，以及人员较集中，空气密度低的场所。
低烟无卤电线特性：(1) 抗张强度比一般PVC电线大：一般PVC电线抗张强度大于1.05Kgf/mm2，而低烟无卤电线抗张强度大于1.2Kgf/mm2；(2) 具有良好的耐候性(-30℃~105℃)；(3) 具备良好的柔软度(硬度为80—90)；(4) 具有非移性(因为此产品配方中不用添加可塑剂，故不会有移形性)；(5) 燃烧时不会产生有毒黑烟(会产生少量白色烟雾)；(6) 具有较高的体积电阻率：PVC电线一般为1012~1015Ω/cm3，低烟无卤电线大于1016Ω/cm3；(7) 具有良好的耐高压特性：PVC电线一般耐10KV以上，而低烟无卤电线高达15KV以上；(8) 具有良好的弹性和粘性。
三相异步电动机的启动电路往往比较大，可能对电源或线路产生较大冲击。对于一些大型异步电动机，启动时可采取星三角降压启动方式，启动时定子绕组接成Y接线方式启动，启动电流大大降低，当电动机速度接近额定转速时定子绕组转为△接线方式运行。图所示为采用时间继电器自动控制Y—△电动机降压启动控制电路。图示星三角降压启动控制电路由接触器、按钮、热继电器、时间继电器组成。接触器KMy用于星形Y降压启动,接触器kM△用于三角形△全压运行,时间继电器KT用来控制Y形降压启动时间及完成Y一△切换。
Tianjin cable pull branch factory in line with the principle of "customer is", with "honest, trustworthy, thoughtful" service concept won the trust of the extensive business. I company for the pre-sale, sale, after-sales service promise as follows: 1, in order to deepen the understanding of our company, we welcome you, experts to visit factory, our company will provide accommodation and convenient work. 2. Provide customers with product price information and product quality information. 3. In order to ensure the high quality of our products, our company adopts domestic high-quality materials and follows the ISO 9001 guarantee system
产品名称产品型号芯数导体截面(m2)聚氯乙烯绝缘和护套铜带屏蔽电缆KVVP2-370.75-10聚氯乙烯绝缘和护套铜带屏蔽铠装控制电缆KVVP2-222-370.75-10聚氯乙烯绝缘和护套控制软电缆KVVR2-370.75-10聚氯乙烯绝缘和护套控制软电缆KVV2-37。